Causes of Charcoal Stick Bending Made by Charcoal Machine

A good charcoal machine, its output, and effect are very good. At the same time, the quality of a charcoal machine can be seen from the effect of the charcoal. Because the quality of the charcoal directly affects the quality and technology of the charcoal machine. Therefore, the quality of the charcoal machine must ensure high standards.

Customers pay attention to the quality of the charcoal machine when they buy the charcoal machine. The quality of the charcoal machine can be seen from the appearance and shape of the salary stick produced by the charcoal machine because the processing of the charcoal machine directly affects the quality of the machine’s product and specification.

If the charcoal stick made by the charcoal machine is bent and deformed, the specifications and quality of the produced charcoal do not meet the standards. The main factors affecting the shape of the charcoal mechanism rod are that the design of the spare parts of the charcoal mechanism rod equipment is not very reasonable and the moisture of the raw material for making the rod does not reach the standard.

1. The design of the accessories of the charcoal mechanism rod equipment is unreasonable: the cross-section gap between the propeller of the rod making machine and the forming cylinder will affect the forming resistance of the raw material, resulting in uneven pressure and flow rate of the basic material when the raw material passes through the propeller. As a result, the forming rod is squeezed. Deformation so is sure to check whether the kinematic combination of the various rod-making accessories is normal before performing the rod-making work.

2. The moisture of raw materials for making rods. The moisture in the raw material has a certain effect on the charcoal mechanism rod. If the moisture in the raw material is too high, the plastic forming standard will not reach the standard hardness during the rod making process, so the extruded salary rod will naturally have a curved shape. Therefore, it is necessary to remove the moisture of the raw materials before making the rod. If the moisture is too high, a dryer can be equipped.

The problems of raw materials and accessories are closely related to the formation of the charcoal machine salary stick. When purchasing a charcoal machine, you must confirm it clearly. Do not be vague about these two aspects, which will cause the charcoal machine to squeeze the bar.